Description
APC Smart-UPS SRT 6000VA 230V
MODEL : SRT6KXLI
-
High density, double-conversion on-line power protection with scalable runtime
-
Includes: CD with software, Documentation CD, Installation guide, Removable support feet, Temperature Probe, USB cable, Warranty card, Web/SNMP Management Card
Key Features
Output power capacity 6.0kWatts / 6.0kVA
Output Connections
(4) IEC 320 C19 (Battery Backup)
(6) IEC 320 C13 (Battery Backup)
(1) Hard Wire 3-wire (H N + G) (Battery Backup)
(2) IEC Jumpers (Battery Backup)
Nominal Output Voltage 230V
Nominal Input Voltage 230V
Input Connections Hard Wire 3 wire (1PH+N+G)
APC Smart-UPS SRT 6000VA 230V
High density, double-conversion on-line power protection with scalable runtime
Includes: CD with software, Documentation CD, Installation guide, Removable support feet, Temperature Probe, USB cable, Warranty card, Web/SNMP Management Card
- 10/100 BaseT Connection
Connect the device to a network using a 10 or 100 BaseT connection
- Battery failure notification
Provides early-warning fault analysis on batteries enabling timely preventive maintenance
- Green mode
Patent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.
- LCD graphics display
Text and mimic diagrams that display modes of operation, system parameters and alarms.
Smart-UPS On-Line Features & Benefits
Serviceability
Audible alarms
Provides notification of changing utility power and UPS power conditions
Disconnected battery notification
Warns when a battery is not available to provide backup power.
User-replaceable batteries
Increases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR)
Automatic self-test
Periodic battery self-test ensures early detection of a battery that needs to be replaced.
Predictive failure notification.
Provides early-warning fault analysis ensuring proactive component replacement.
Protection
Power conditioning
Protects connected loads from surges, spikes, lightning, and other power disturbances.
Frequency and voltage regulation
Gives higher application availability by correcting poor frequency and voltage conditions without using the battery.
Safety-agency approved
Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.
Resettable circuit breaker
Easy recovery from overloads; no need to replace a fuse. (Not available on Wall Tap SKUs)
Cold-start capable
Provides temporary battery power when the utility power is out.
Generator compatible
Ensures clean, uninterrupted power to protected equipment when generator power is used.
Input power factor correction
Minimizes installation costs by enabling the use of smaller generators and cabling.
Technical Specifications
Output
Max Configurable Power (Watts) 6.0kWatts / 6.0kVA
Output Voltage Distortion Less than 2%
Output Frequency (sync to mains) 50/60Hz +/- 3 Hz
Other Output Voltages 220, 240
Load Crest Factor 3 : 1
Topology Double Conversion Online
Waveform type Sine wave
Bypass Internal Bypass (Automatic and Manual)
Input
Input frequency 40 – 70 Hz (auto sensing)
Input voltage range for main operations 160 – 275V
Input voltage adjustable range for mains operation 100 – 275 (half load)V
Other Input Voltages 220, 240
Batteries & Runtime
Battery type Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
Typical recharge time 1.5hour(s)
Nominal Battery Voltage 192V
Replacement Battery APCRBC140
Expected Battery Life (years) 3 – 5
RBC Quantity 1
Extendable Run Time 1
Battery Volt-Amp-Hour Capacity 902
Communications & Management
Interface Port(s) RJ-45 10/100 Base-T, RJ-45 Serial, Smart-Slot, USB
Control panel Multi-function LCD status and control console
Audible Alarm Audible and visible alarms prioritized by severity
Emergency Power Off (EPO) Yes
Available SmartSlot™ Interface Quantity 1
Surge Protection and Filtering
Surge energy rating 480Joules
Physical
Maximum Height 432MM, 43.2CM
Maximum Width 174MM, 17.4CM
Maximum Depth 719MM, 71.94CM
Net Weight 60.0KG
Shipping weight 67.0KG
Shipping Height 370MM, 37.0CM
Shipping Width 610MM, 61.0CM
Shipping Depth 960MM, 96.0CM
Color Black
Units per Pallet 6.0
Environmental
Operating Temperature 0 – 40 °C
Operating Relative Humidity 0 – 95 (non-condensing) %
Operating Elevation 0-3000meters
Storage Temperature -15 – 45 °C
Storage Relative Humidity 0 – 95 (non-condensing) %
Storage Elevation 0-15000meters
Audible noise at 1 meter from surface of unit 55.0dBA
Online thermal dissipation 1300.0BTU/hr
Protection Class IP 20
Conformance
Approvals CE, CE Mark, EAC, EN/IEC 62040-1, EN/IEC 62040-2, IRAM, RCM, VDE
Standard warranty 3 years repair or replace (excluding battery) and 2 years for battery
Sustainable Offer Status
RoHS Compliant
REACH REACH: Contains SVHCs
Reviews
There are no reviews yet.